Tremec has built a running manual-transmission C8 Corvette development car, and it is not a rumor or a mock-up. The company invited a reporter and several potential customers to sample its transmissions at Motorsports Gateway, a private track outside Howell, Michigan. There, the reporter drove a one-of-one Peitz Performance C8 race car fitted with Tremec’s new manual gearbox.
The car exists because the C8 represented a major pivot for Chevrolet. It was the first Corvette with the engine behind the driver, and the first offered only with a dual-clutch automatic. After decades of front-engine development, Chevrolet faced the cost of engineering two new transaxles, one manual and one automatic, for a mid-engine layout. Developing two gearboxes was not in GM’s budget. The choice favored comparison-test performance over a small group of manual enthusiasts.
The development car is very much a track build. Its interior fit and finish is essentially absent. The shifter protrudes from the space where the storage cubby and automatic gear selector normally sit. The car has a full roll cage and harness. It also has almost no seat adjustment, which suited a taller driver better than the 5-foot-7-inch reporter. He could not touch the floor with either foot to brace himself or execute a clean heel-toe downshift, so he did not push the car especially hard. The test took place on a green track on a November afternoon in Michigan.
Packaging proved less difficult than the manual’s rarity might suggest. Peitz had to cut the tunnel to install the clutch pedal hardware, but the manual gearbox otherwise sits where the stock dual-clutch unit would, with no elaborate mating hardware. The C8’s pedal box has ample room for a clutch pedal; even with the third pedal, the reporter found it roomier than a last-generation Camaro’s.
The driving experience comes with a mid-engine caveat. The shifter is remotely mounted, with a cable running rearward to the transaxle. That makes it less precise and less snick-snick than the front-engine TR-6060 six-speed, and also less notchy. Some drivers may prefer the smoother action; others may miss the more mechanical feel of the front-engine installation. Moving the engine forward or the shifter rearward would be the only fixes, and each would bring its own packaging penalty.
Cost remains the larger obstacle. Tremec says the gearbox alone costs about $75,000. Combined with the price of a Corvette, building a manual C8 rivals a showroom-spec Z06. Tremec expects the price to fall as volume rises. It says OEMs are interested, not necessarily or exclusively General Motors, and that other automakers want a high-torque manual transaxle. The car therefore demonstrates that a manual C8 can work, but it does not confirm a Chevrolet production program.
