Off-Roader Builds Rear-Only Portal Axle for a Fifth of Typical Cost

Zeph Gage combined a Ford 9-inch housing, Humvee geared hubs and an upside-down differential to raise the clearance of his XJ Jeep without buying a full portal axle set.

Portal axles are prized by hardcore off-roaders because they lift a vehicle and help it clear obstacles, but a set from specialists such as 74Weld typically costs around $20,000. A build by Zeph Gage shows a cheaper route at about a fifth of that price, achieved partly by fitting a portal only to the rear of his Jeep.

What portal axles do

As The Drive's Andrew Collins has explained, portal axles place a stack of gears behind each driven wheel instead of leaving shafts and other components hanging below the transmission and transfer case. That arrangement lets the axle shafts sit high, so very little hardware sits below the frame line. Paired with tall tires, it creates enough ground clearance that, in Collins' description, there would be room for a picnic underneath a parked vehicle.

How the budget version works

Gage's unit combines a Ford 9-inch axle housing, geared hubs taken from a Humvee and a set of Jesse Haines Fabrication HMMWV portal adapters. Two-gear portals like the Humvee's reverse the rotation of the input shaft. To compensate, Gage mounted the differential upside down so the driveline turns in the correct direction, then bolted a Yukon Gear and Axle third member to it, turning low-pinion components into what amounts to a high-pinion setup.

Benefits beyond clearance

Besides adding six inches of clearance, the arrangement retains full shock travel, which the article notes is tricky to achieve with portal axles, and it reduces stress on the differential itself. The report describes the result as effectively bulletproof.

Why only the rear

Fitting a portal at the back alone is a common trick in the remote-control rock crawler scene. Keeping the solid axle up front meant Gage did not have to deal with the packaging constraints that typically arise when portal axles are added to a vehicle that never had them from the factory. He also avoided restricting shock travel because of those constraints, and the ride height was not raised absurdly high, a combination the report frames as a compromise-free result.

Custom fabrication

The conversion is not an off-the-shelf solution. Gage carried out extensive custom work, including homemade brackets, custom-tapped plates and a two-piece brake rotor paired with a Ford Fusion caliper. He chose the Fusion hardware partly because it offers an integrated electric emergency brake solenoid and partly for clearance reasons.

The finished XJ Jeep can drive over a five-gallon bucket and still have several inches of spare clearance, so the rear end will not hang up on obstacles the front can simply steer around. Gage detailed the build, including how he matched gearing front and rear, in a video from Outdoor Auto.

AB

Astrid Berglund

Astrid writes as a vehicle cargo and roof system analyst covering roof racks, roof boxes, baskets, roof tents, and vehicle-mounted sports carriers. Her assessments work from documented roof load limits, crossbar spacing, mounting points, and rated carrier capacity, and separate static parked loads from dynamic driving cases rather than treating a box or basket label as a vehicle rating. She supports aftermarket buyers, outdoor equipment distributors, and installation teams who must confirm fitment, request test evidence, and manage packaging, returns, and lifecycle cost.