Emulsion buffer layer curbs screen-printing damage in copper-plated HJT cells

Chinese researchers trace efficiency losses to worn screen mesh knuckles and find that 4.7% emulsion coverage keeps lifetime degradation low.

Screen printing is a workhorse of solar cell metallization, but the process can itself degrade device performance. The issue is especially acute for copper-plated silicon heterojunction (HJT) solar cells, which are seen as a promising route to cutting metallization costs and reducing reliance on silver. The mechanical pressure and thermal treatment involved in printing can damage the cells' sensitive passivating contact structures, raising recombination losses and lowering conversion efficiency.

A different kind of screen

Corresponding author Lang Zhou told pv magazine that photoresist printing for HJT cells differs fundamentally from conventional silver paste printing. In silver paste printing, screen openings cover only 2–5% of the total area, and an emulsion layer over the rest of the screen keeps the mesh from touching the wafer. Full-area photoresist coating, by contrast, typically uses a screen with no emulsion coverage so that resist is deposited evenly across the whole wafer, meaning the mesh comes into direct, extensive contact with the wafer on every printing cycle.

Quantifying the loss

Earlier investigations cited by the researchers found conversion efficiency falling from 26.2% to 25.7% over 15,000 consecutive printing cycles in commercial solar cell production. The losses were mainly attributed to lower open-circuit voltage and fill factor, while short-circuit current density and electrical resistance stayed largely unchanged. Minority carrier lifetime degradation rose from 0.61% with a new screen to 11.0% after 15,000 cycles.

Using three-dimensional confocal microscopy, the team identified progressive wear of the screen mesh knuckles as the main cause. As the knuckles wore down, their contact area with the wafer grew, placing greater mechanical stress on the passivation layers underneath. Scanning electron microscopy showed no visible surface scratches, but photoluminescence measurements confirmed higher recombination losses, pointing to damage at the sensitive amorphous silicon/crystalline silicon interface.

An emulsion buffer layer

To address this, the researchers developed an emulsion buffer layer that keeps the mesh from touching the wafer surface. They evaluated six patterns with emulsion coverage ratios from 2.9% to 16.6%. The results showed a trade-off between mechanical protection and photoresist coating uniformity: higher coverage reduced damage but impaired ink distribution. A coverage ratio of 4.7% gave the best balance, holding minority carrier lifetime degradation to 0.41% after 10,000 printing cycles while maintaining relatively good coating uniformity.

The improvement was attributed to the emulsion layer preventing direct contact between mesh and wafer, thereby limiting cumulative mechanical damage to the passivation layers. Zhou said the findings show that a relatively simple modification to screen design can substantially mitigate printing-induced degradation, offering a practical way to improve the manufacturing reliability of copper-plated HJT cells. The work was published in Solar Energy.

Copper metallization gathers pace

The result comes as interest in copper contacts grows. In April 2026, researchers at China's Nankai University reported a silver-free HJT cell with 25.2% efficiency, using plasma-induced interface engineering and copper electroplating to address adhesion, contact resistance and stability at the indium tin oxide interface. Separately, scientists at Germany's Forschungszentrum Jülich reached 23.08% in a fully copper-metallized HJT cell, a relatively small penalty versus its silver-metallized counterpart, while cells combining silver-copper paste on the front and silver contacts on the rear reached 23.95%. Both results underline copper's potential to cut silver consumption, though further gains in processing and electrical performance are still needed.

TA

Tariq Al-Masri

Tariq Al-Masri covers pressure and temperature instrumentation, including process transmitters, thermocouples, pressure gauges, and related sensors used in industrial measurement. His analysis compares measurement range, drift, repeatability, and calibration uncertainty while checking how a 4-20 mA output fits the stated control system and operating conditions. He helps instrumentation engineers and maintenance buyers specify credible replacements, evaluate evidence on measurement performance, and avoid installation choices that would weaken process data quality.